Error Messages; Safety, Care, Accuracy Test And Disposal - Microlife BP A1 Easy Instructions Manual

8. Error Messages

If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «ERR 3», is displayed.
Error Description Potential cause and remedy
«ERR 1» Signal too The pulse signals on the cuff are too
weak weak. Re-position the cuff and repeat
the measurement.*
«ERR 2» Error signal During the measurement, error signals
were detected by the cuff, caused for
AL
instance by movement or muscle
tension. Repeat the measurement,
keeping your arm still.
«ERR 3» No pres- An adequate pressure cannot be gener-
sure in the ated in the cuff. A leak may have
AK
cuff occurred. Check that the cuff is correctly
connected and is not too loose. Replace
the batteries if necessary. Repeat the
measurement.
«ERR 5» Abnormal The measuring signals are inaccurate
result and no result can therefore be
displayed. Read through the checklist
for performing reliable measurements
and then repeat the measurement.*
«HI» Pulse or cuff The pressure in the cuff is too high (over
pressure too 300 mmHg) OR the pulse is too high
high (over 200 beats per minute). Relax for 5
minutes and repeat the measurement.*
«LO» Pulse too The pulse is too low (less than 40 beats
low per minute). Repeat the measurement.*
* Please consult your doctor, if this or any other problem occurs
repeatedly.

If you think the results are unusual, please read through the
information in «Section 1.» carefully.

9. Safety, Care, Accuracy Test and Disposal

Safety and protection
 This device may only be used for the purposes described in
these instructions. The manufacturer cannot be held liable for
damage caused by incorrect application.
BP A1 Easy
 This device comprises sensitive components and must be
treated with caution. Observe the storage and operating condi-
tions described in the «Technical Specifications» section.
 Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
- heat and cold
 The cuffs are sensitive and must be handled with care.
 Do not exchange or use any other kind of cuff or cuff connector
for measuring with this device.
 Only pump up the cuff once fitted.
 Do not use this device close to strong electromagnetic fields
such as mobile telephones or radio installations.
 Do not use this device if you think it is damaged or notice
anything unusual.
 Never open this device.
 If the device is not going to be used for a prolonged period the
batteries should be removed.
 Read the additional safety information in the individual sections
of this instructions.
Ensure that children do not use this device unsupervised;
some parts are small enough to be swallowed.
Device care
Clean the device only with a soft, dry cloth.
Cleaning the cuff
Carefully remove spots on the cuff with a damp cloth and soapsuds.
WARNING: Do not wash the cuff in a washing machine or
dishwasher!
Accuracy test
We recommend this device is tested for accuracy every 2 years or
after mechanical impact (e.g. being dropped). Please contact
Microlife-Service to arrange the test (see foreword).
Disposal
Batteries and electronic devices must be disposed of in
accordance with the locally applicable regulations, not with
domestic waste.
EN
5