Cisco EHWIC-4SHDSL-EA Configuration Manual page 8

Configuring Cisco G.SHDSL EFM/ATM
DETAILED STEPS
Command
Step 1
controller shdsl slot number/subslot number/0
For EHWICs, use the three-tuple notation
Note
(slot number/subslot number/0) shown here. For
fixed platforms, use the single-tuple notation
(slot number).
Example:
Router# conf t
Router(config)# controller shdsl 0/3/0
Step 2
dsl-group DSL_group_number pairs link-number
Example:
Router(config-controller)# dsl-group 0 pairs 0
Router(config-controller-dsl-group)#
Step 3
shdsl rate {number | auto}
Example:
Router(config-controller-dsl-group)# shdsl rate
2304
For more information, refer to the
section on page 49.
Step 4
exit
Example:
Router(config-controller-dsl-group)# exit
Router(config-controller)#
Step 5
exit
Example:
Router(config-controller)# exit
Router(config)#
Step 6 For EFM mode:
interface Ethernet
Example:
Router(config)# interface ethernet 0/3/0
Router#
For ATM mode:
<
interface atm
Example:
Router(config)# interface atm 0/3/0
Router#
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
8
"Command Reference"
< >/< >/
slot subslot <0>
> < >
slot / subslot /<0>
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
Purpose
Selects controller and enter DSL group configuration
mode.
Note See the "Configuring Cisco G.SHDSL
EFM/ATM" section on page 4
creating and configuring DSL groups.
Selects DSL pair link number.
Selects rate for controller.
Exits dsl-group configuration mode.
Exits controller configuration mode.
For EFM mode:
Enters the interface Ethernet configuration mode.
For ATM mode:
Enters the interface atm configuration mode.
for details about