Cisco EHWIC-4SHDSL-EA Configuration Manual page 67

Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
mode
To specify the symmetric high bit rate digital subscriber line (SHDSL) mode of operation, use the mode
command in the configuration controller mode. To disable the command, use the no form of this
command for your model number. The no form of this command sets the mode to ATM.
Syntax Description
atm
efm
Command Default By default, the mode is set to ATM for Cisco EHWIC-4SHDSL-EA and Cisco 888-EA ISRs.
Command Modes Configuration controller (config-controller)
Command History Release
15.2(2)T
Usage Guidelines Use the ATM mode for EHWIC-4SHDSL-EA and Cisco 888-EA models, and use the EFM mode for the
EHWIC-8SHDSL-E model.
Examples The following example shows how to use the mode command to configure a Cisco
EHWIC-4SHDSL-EA card installed in a Cisco Access router:
Router(config-controller)# mode efm
Router(config-controller)#
Related Commands Command
show controller shdsl
controller shdsl
mode [atm | efm]
no mode
ATM mode.
EFM mode.
Modification
This command was introduced to support the Cisco EHWIC-4SHDSL-EA
and Cisco 888-EA ISRs.
Description
Displays the controller status and statistics.
Configures a controller in SHDSL mode.
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
mode
67