Cisco EHWIC-4SHDSL-EA Configuration Manual page 75

Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
show controllers shdsl
To display the status of the controller configured for symmetric high bit rate digital subscriber line
(SHDSL) mode, use the show controllers shdsl command in privileged EXEC mode.
Cisco EHWIC-4SHDSL-EA,
Cisco 888EA
Syntax Description
brief
detailed
number
slot number
subslot number
port number
Command Default Controller number
Command Modes
Privileged EXEC
Command History Release
12.4(15)T
12.2(8)T
15.1(1)T
15.2(2)T
Usage Guidelines This command is used to display the controller mode, the controller number, and associated statistics.
Examples
Cisco HWIC-4SHDSL, and HWIC-2SHDSL
The following example shows the status of a Cisco HWIC-4SHDSL controller in slot 0, subslot 2, port
0 on a Cisco access router:
show controllers shdsl slot number/subslot number/port number {brief | detailed}
show controller shdsl number
Provides a summary of the controller's status.
Provides a detailed report of the controller's status.
SHDSL controller number. The valid controller number for SHDSL mode
is 0.
Slot on the router in which the HWIC is installed.
Subslot on the router in which the HWIC is installed.
Port on the router in which the HWIC is installed. By default, the
Cisco HWIC-4SHDSL-E, HWIC-4SHDSL, and HWIC-2SHDSL use port
number 0.
Modification
This command was updated for the Cisco HWIC-4SHDSL and
HWIC-2SHDSL running on the Cisco 1841 router and on the Cisco 2800
and 3800 series access routers.
This command was introduced on Cisco IAD2420 series.
This command was modified. Support for the Cisco HWIC-SHDSL-E was
added.
This command was modified to support the Cisco EHWIC-4SHDSL-EA.
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
show controllers shdsl
75