Cisco EHWIC-4SHDSL-EA Configuration Manual page 73

Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
dsl-group
For the HWIC-4SHDSL
Router(config-controller)# dsl-group 0 pairs 0-1 ima
Router(config-controller-dsl-group)#
Sep 14 13:15:40.285:%HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/2/0 dsl-group(1) state changed
to down.
Sep 14 13:15:42.285:%LINK-3-UPDOWN: Interface ATM0/2/IMA1, changed state to down
Sep 14 13:15:43.285:%LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/IMA1, changed
state to down
For the EHWIC-4SHDSL-EA
Router(config)#
Router(config)# controller shdsl 0/2/0
Router(config-controller)# dsl-group 0 pairs 0-1 ima
Router(config-controller-dsl-group)#
*Oct 1 10:49:03.331: %LINK-3-UPDOWN: Interface ATM0/2/IMA0, changed state to down
*Oct 1 10:49:04.331: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/IMA0, changed
state to down
Router(config-controller-dsl-group)# shdsl rate 2048
Router(config-controller-dsl-group)# exit
Router(config-controller)# exit
Router(config)#
The following example shows how to use the dsl-group auto command to automatically adopt the
Central Office (CO) configuration on an ATM group:
Router(config-controller)# dsl-group auto
Router(config-controller-dsl-group-auto)#
*May 14 18:56:33.136: %HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/0/0 dsl-group(0) state
changed to down.
*May 14 18:56:35.136: %LINK-3-UPDOWN: Interface ATM0/0/0, changed state to down
*May 14 18:56:36.136: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/0/0,
changed state to down
The following example shows how to configure a single-pair DSL group and enters the configuration
controller DSL group mode:
Router(config-controller)# dsl-group 0 pairs 0
Router(config-controller-dsl-group)#
The following example shows how to create a 4-pair EFM bonding group:
Router(config-controller)# dsl-group 0 pairs 0-3 efm-bond
Router(config-controller-dsl-group)#
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
73