Cisco EHWIC-4SHDSL-EA Configuration Manual page 52

shdsl annex
Examples The following example shows how to use the shdsl annex command to define the annex standard for an
EFM 2-Pair DSL group on a Cisco EHWIC-4SHDS-EA interface card:
Router(config-controller-dsl-group)# shdsl annex ?
A
A-F
B
B-G
F
G
Router(config-controller-dsl-group)# shdsl annex F coding ?
128-TCPAM
16-TCPAM
32-TCPAM
64-TCPAM
Router(config-controller-dsl-group)# shdsl annex F coding 32-TCPAMxrw
The following example shows how to verify the shdsl annex command:
show running-config :
controller SHDSL 0/1/0
termination co
mode efm
dsl-group 0 pairs
shdsl annex F coding 32-TCPAM
ignore crc
shdsl rate auto
handshake itut
!
show controller
show controll shdsl 0/1/0
Controller SHDSL 0/1/0 is UP
Hardware is EHWIC-4SHDSL-EA, rev 0 on slot 0, hwic slot 1
Capabilities: EFM: 2-wire, EFM-Bond, Annex A, B, F & G
CO termination
cdb=0x3CC11EC0, plugin=0x3CC0AAC0, ds=0x21A70F3C base=0x10200000
FPGA Version is A14
NPU Source: System
NPU Firmware version: SHDSL_EA_FW_20130320073751
Vendor: Infineon, Chipset: SOCRATES-4e
PHY Source: System
IDC Firmware version: 1.7.5.0
DFE Firmware version: 1.1-1.7.5__002
Firmware reload mode: Auto
Group info:
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2
52
Annex A of G.991.2 standard
Annex A/F of G.991.2 standard
Annex B of G.991.2 standard
Annex B/G of G.991.2 standard
Annex F of G.991.2 standard
Annex G of G.991.2 standard
128-TCPAM line coding
16-TCPAM line coding
32-TCPAM line coding
64-TCPAM line coding
0
6
:
ATM: 2-wire, Mpair, IMA, Annex A, B, F & G
Type: EFM 2-wire status: Up
Ethernet Interface: Ethernet0/1/0, hwidb: 0x3CC13E8C
ATM Interface: ATM0/1/0, hwidb: 0x3CC75F64
Currently active interface: Ethernet
Configured/active num links: 1/1, bit map: 0x1/0x1
Line termination: CO, Annex: F
PMMS disabled,Line coding: 32-TCPAM
Configured/actual rate: AUTO/5696 kbps
Loopback type: None
SHDSL wire-pair (0) is in DSL UP state
LOSWS Defect alarm: none
SNR Margin alarm: none
Configuring Cisco Multimode G.SHDSL EFM/ATM in Cisco ISR G2