Table of Contents
Advertisement
5.4
Wiring SLC Detectors
This section describes how to install heat and smoke detectors. All detectors ship with
installation instructions. Refer to the detector's installation instructions for more detailed
information.
This information applies to the following HFS or SK models:
•
HFS-P, HFS-PA, SK-Photo - Photoelectric Smoke Detector
•
HFS-PT, HFS-PTA, SK-Photo-T - Photoelectric Smoke Detector with Thermal
•
HFS-D, HFS-DA, SK-Duct - Photoelectric Duct Detector
•
HFS-T, HFS-TA, SK-Heat - Fixed Temperature Detector
To wire HFS or SK detectors:
1. Wire device bases as shown in Figure 5-3.
2. Set the address for each device as described in Section 5.5.
Supervised
Power limited
Figure 5-3 Heat and Smoke Detector Connection to the Panel.
151450
SLC Device Installation
5-5
Advertisement
Table of Contents
