Table of Contents
Advertisement
4.5.1
Mounting the 5635
This section of the manual describes mounting the remote annunciator. Figure 4-11 shows the
parts of the annunciator.
Inside Cover
LCD Display
The 5635 Series plastic enclosures can be surface or semi-flush mounted in a single, double or
4" square electrical box.
To mount the 5635 Series enclosure:
1. Open the 5635 Series cover by turning the key switch counterclockwise to the ON
(Unlocked) position.
2. Push in the snap latch tab located on the right side while pulling the cover open.
3. Pull wire through 7/8" hole in backplate and feed through wire channel to lower left cor-
ner of backplate before routing to terminal block.
4. The cover must remain attached to the backplate while mounting the annunciator to the
electrical box/ wall. The cover cannot be reattached or removed after the annunciator has
been mounted.
5. Surface or Semi-flush mount the 5635 to a single, double or 4" square electrical box. The
ANN-SB80KIT(-R/-B/-W) is an available kit that contains two plastic backboxes that can
be used to surface mount the 5635.
151450
Back Box
Figure 4-11 5635 Annunciator Parts
Control Panel Installation
4-13
Advertisement
Table of Contents
