Table of Contents
Advertisement
Model 5600/5600C/5600HV Basic Operating Instructions
These Instructions must be framed and displayed next to the5600 panel in
accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems. Test
the system in accordance to NFPA 72. Refer to Installation Manual P/N 151450
for more information regarding this control panel.
Operation
Silence Alarms and
Troubles
Reset Alarms
Acknowledge Alarms and
Troubles
View Alarms
View Supervisories
View Troubles
Conduct a Fire Drill
Dialer Test
Lamp Test
Enable / Disable a Zone or
Circuit
Remote Connection
Feature (ULC Installations
Only)
For Service call:
P/N 53610
Rev. A
Press
. Silence LED will light.
Press
.
Press
.
Zones that are in alarm will have their alarm LED on. To view all points in
alarm press Alarm ID followed by
each point.
Zones that are in supervisory will have their supervisory LED on. To view all
points in supervisory press Supervs ID followed by
the SLC ID for each point.
Zones that are in trouble will have their trouble LED on. To view all points in
trouble press Trouble ID followed by
each point.
1. Press
to start Fire Drill.
1
2. Press
to end Fire Drill.
Press
and
key at same time.
Press
and
key at same time.
Press the corresponding disable key. Press it again to enable the zone or
circuit. For ULC, you must enter the Installation code after pressing Zone
Enable/Disable.
Press the
and
paths to the Central Station and/or remote station. The PZT on the panel will
sound and the General Trouble LED will be flashing. This will remain active
until you press the Walk test and Acknowledge buttons again.
ECN 10-157
Task to Perform
or
button to view the SLC ID for
or
button to view the SLC ID for
at the same time to disconnect the communication
or
button to view
Advertisement
Table of Contents
