Model 5600 Installation and Operation Manual
4.1.3
Dead Front Installation and removal
This section provides instructions to install and or remove the dead front for the control panel
cabinet.
4.1.3.1 Installing the Dead Front
Follow these steps to properly install the dead front panel into the control panel cabinet.
1. Remove the top two annunciator screws, do not discard them they will be reused. See
Figure 4-1 for annunciator screw location.
2. Set the dead front into the cabinet as shown in Figure 4-1.
3. Reinsert the two annunciator screws as shown in Figure 4-1.
4-2
Figure 4-1 Dead Front Installation and Removal
Dead Front
Panel
151450