Stopping The Engine; Starting The Engine - Triumph Scrambler 1200 XE Owner's Handbook Manual

How to Ride the Motorcycle

Stopping the Engine

1
N
Fuel
HOLD TO RESET
1. Neutral indicator
2. Engine stop switch - STOP position
3. Master ignition switch - OFF position
(if fitted)
To stop the engine:
• Close the throttle completely.
• Select neutral.
• Place the engine stop switch in the
STOP position.
• Turn the master ignition switch to
the OFF position (if fitted).
• Select first gear.
• Support the motorcycle on a firm,
level surface with the side or centre
stand.
• Lock the steering.
Do not leave the ignition switched
on with the engine stopped. This will
cause electrical damage.
92
2
Caution

Starting the Engine

3
Never start the engine or run the
engine in a confined area.
Exhaust fumes are poisonous and can
cause loss of consciousness and death
within a short period of time.
Always operate your motorcycle in the
open air or in an area with adequate
ventilation.
The low oil pressure warning light
should go out shortly after the engine
starts.
If the low oil pressure warning light
stays on after starting the engine,
stop the engine immediately and
investigate the cause.
Running the engine with low oil
pressure will cause severe engine
damage.
1. Master ignition switch - ON position
(if fitted)
2. Engine stop switch - QUICKSTART position
3. Neutral indicator
To start the engine:
• Make sure that the master ignition
switch (if fitted) is turned to the ON
position.
Warning
Caution
1 2 3
N
Fuel
HOLD TO RESET