Preparing For Installation; Identifying Controller Components - HP MSM775 zl Installation Manual

1 Preparing for installation

The MSM775 zl Premium Controller is a Services zl Module-based WLAN controller that plugs
into switches such as the 5406 zl and 8212 zl. New switches need to be prepared according to
their documentation.
NOTE: The MSM775 zl Controller requires software Version K.15.13 or later on the switch.

Identifying controller components

Front panel and LEDs
Figure 1 Controller front panel
1
1. Module Status LED
2. Module Reset button
Front panel LEDs indicate the following:
LED
Module Status
(green/orange)
Module Locator (blue)
SSD Activity (green)
Network Activity (green)
4 Preparing for installation
2 3
5 4
3. USB port (not used)
4. SSD Activity and Network Activity LEDs
State
On green
Flashing green
Flashing orange
Off
On
Flashing
Off
Flashing
Off
Flashing
Off
5. Module Locator LED
Meaning
The controller is ready.
The controller is starting or has booted into the service OS.
An error has occurred.
The controller is powered off.
The services <slot-id> locator on command was
issued to assist in finding the controller.
The services <slot-id> locator blink command
was issued to assist in finding the controller.
nl
Note: The flashing duration defaults to 30 minutes, but can
be set anywhere from 1 minute to 1440 minutes.
Default state. Otherwise, the services <slot-id>
locator off command was issued or a previous blink
request has timed out.
The SSD is active.
The SSD is not active.
There is network activity on one or both internal ports.
There is no network activity on either internal port.