Preparing For Installation; Identifying Controller Components - HP MSM765 zl Installation Manual

1 Preparing for installation

The MSM765 zl Mobility Controller is a Services zl Module-based WLAN controller which plugs
into switches such as the 5400 zl and 8212 zl. New switches must be prepared according to their
documentation.

Identifying controller components

Front panel port and LEDs
Figure 1 Controller front panel
1
1. Module Status LED
2. Module Locator LED
3. HDD Status and Compact Flash Status LEDs
USB Port: This port is used to attach a USB device, such as a flash drive.
The following table describes the LEDs on the front panel.
LED
Module Status
(green/orange)
Module Locator
(blue)
CF (Compact Flash)/HDD
Status (green/orange)
4 Preparing for installation
2 3 4
State
Flashing green
On green
Flashing/on orange
Flashing/on
On green
On orange
5
4. HDD Activity and Network Activity LEDs
5. USB port
Meaning
Initialization was successful. Stays in this state when the
controller is booted to Service OS.
Controller is operational.
Error condition
This LED is off by default.
Flashing cycle (green or orange) is 400ms on – 400ms off.
At boot, the Module Status, HDD Status, and CF Status LEDs
are green for ~2s, then orange for ~2s, then back to green
for ~1s, and finally all are turned off.
On during boot only when the controller is inserted into a
chassis, soft reboots do not enable this LED. Used to locate
a specific module in an area full of chassis. Enabled by
using the following switch CLI command:
services <slot ID> locate <blink [duration]
| off | on [duration]>
This LED is off by default.
CF/HDD has initialized.
CF/HDD is not detected.
This LED is off by default.