Installation Precautions - HP ProCurve 800 Hardware Installation Manual

Installation Precautions:

Follow these precautions when installing the ProCurve NAC 800 appliance.
Wa r n i n g
■
■
C a u t i o n s
■
■
■
■
■
■
The rack or cabinet should be adequately secured to prevent it from
becoming unstable and/or falling over.
Units installed in a rack or cabinet should be mounted as low as possible,
with the heaviest devices at the bottom and progressively lighter devices
installed above.
For safe operation, only install the unit horizontally, with the bottom side
down.
Ensure the power source circuits are properly grounded, then use the
power cord supplied with the unit to connect it to the power source.
If your installation requires a different power cord than the one supplied
with the unit, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The
mark is your assurance that the power cord can be used safely with the
unit.
When installing the unit, the AC outlet should be near the unit and should
be easily accessible in case the unit must be powered off.
Ensure the unit does not overload the power circuits, wiring, and over-
current protection. To determine the possibility of overloading the supply
circuits, add together the ampere ratings of all devices installed on the
same circuit as the ProCurve NAC unit and compare the total with the
rating limit for the circuit. The maximum ampere ratings are usually
printed on the devices near the AC power connectors.
Do not install the unit in an environment where the operating ambient
temperature might exceed 40°C (104°F).
Ensure the air flow around the sides and back of the unit is not restricted.
Quick Install
Quick Install Summary
2-3