Information About Errors - Nissei DSK-1031 Instruction Manual

3. Memory unit number, measurement date and time will be displayed one by one
in the upper right corner of the display.
4. The result saved in the memory unit 1 is the most recent among the saved data in
the selected memory. The higher memory number, the older the result.
The memory data are displayed for about 30 seconds and after that, if no button is
pressed, the device is automatically turned off .
Pressing the button switches the display from records in the memory unit 1 to
records in the memory unit 2, while pressing the
data recorded in the memory unit 1.
5. Press the START/STOP button to turn off the device.
Deletion of Saved Data
Readings can be deleted unit by unit: all together or separately. The memory may be
cleared when the selected memory unit contains two or more results.
1. Select a value from the memory unit to be deleted or the average value (unit with
index « ») to clear the whole memory unit.
2. Press and hold the button or

INFORMATION ABOUT ERRORS

INDICATION LIKELY CAUSE
Blood pressure is too The cuff is not at the heart level.
low or too high. The cuff is put on incorrectly.
During the measurement, a person
was talking or moving.
Measurement results Eff ect of measurement conditions,
are diff erent each time. physical or mental state.
Measurement results Eff ect of relaxed state at home and
are diff erent in clinic tension in clinic.
and at home.
Infl ation is repeated. Pressure can not be measured due to
movement or talking.
button results in returning to
until the sign «---» appears on the display.
METHODS OF CORRECTION
Put on the cuff at the heart level.
Check the cuff position on the hand.
Be calm and quiet during the
measurement.
Take measurements under the same
conditions.
Show the pressure records made at
home to your doctor for advice.
Re-infl ation is not a malfunction of
the device. Do not talk and do not
move during the measurement.
Maximum allowable pressure:
pressure can not be measured due
to movement or talking during
the measurement, in spite of the
fact that the cuff was pumped at
maximum.
Pressure can not be measured due to
movement or talking.
or
Cuff is not securely connected to
the device.
Cuff is not put on properly.
No time indication on Time was not set.
the display. Note: there is no time indication when
batteries and/or power source are not
provided.
Date and time are Time was not set or measurements
displayed as «--/--». were carried out before setting the
time.
Batteries are discharged.
Nothing is shown on Batteries are discharged.
the display. Batteries are installed incorrectly.
Connecting terminals are
contaminated.
Power source is not connected.
Insuffi cient contact when touching
the button.
8
Do not talk and do not move during
the measurement.
Do not talk and do not move during
the measurement.
Check the connection.
Make sure that the cuff is put on
correctly.
Set time and date.
Install batteries and connect the
power source.
Set date and time.
Date and time can not be saved
without setting.
Replace all batteries with new ones.
Replace all batteries with new ones.
Install batteries properly.
Wipe connecting terminals with a
dry cloth.
Connect the power source.
Ensure stronger pressing the button.