Care, Storage, Repair And Disposal; Certification And State Registration - Nissei DSK-1031 Instruction Manual

Hide thumbs Also See for DSK-1031:
Table of Contents

Advertisement

CARE, STORAGE, REPAIR AND DISPOSAL

1. This device should be protected from excessive moisture, direct sunlight, strokes,
and vibration. THE DEVICE IS NOT WATERPROOF.
2. Do not keep or do not use the device in close proximity to heaters and open fl ame.
3. If the Device was stored at a temperature below the freezing point, keep it at least
for 1 hour in some warm place before use.
4. If the device has not been used for a long time, remove the batteries. Leaking of
batteries can cause damage to the device and terminate the warranty. KEEP BAT-
TERIES AWAY FROM CHILDREN!
5. Do not contaminate the device and protect it from dust. The device can be
cleaned with a dry, soft cloth.
6. Do not allow the contact between the device and its parts with water, solvents,
alcohol, and gasoline.
7. Keep the cuff away from sharp objects, and do not try to pull out the cuff .
8. Do not expose the device to strong strokes and do not throw it.
9. The device does not contain any adjustment controls for settings. Unauthorized
opening of the electronic device is forbidden. If needed, repair the device only in
specialized organizations.
10. On the expiry of the specifi ed operation term, refer to specialists (specialized repair
organizations) on a periodic basis to check the technical condition of the device.
11. When utilizing the waste, refer to current rules applicable in your region. No spe-
cial utilization conditions are specifi ed by the manufacturer for this device.
12 . The cuff is resistant to repeated sanitation. The cuff internal fabric surface (being
in contact with a patient' hand) can be treated with a cotton swab moistened in a
3% solution of hydrogen peroxide. Partial discoloration of the cuff covering tissue
is possible if used for a long time. Do not wash the cuff and do not treat it with a
hot iron.
13. Do not leave unattended the device plugged into the network.

CERTIFICATION AND STATE REGISTRATION

The production of devices is certifi ed pursuant to international standards such as
ISO 9001, ISO 13485, ISO 14001:2004.
The device meets international standards IEC60601-1:2005+CORR.1:2006+
CORR.2:2007, IEC60601-1-2:2001+A1:2004/IEC60601-1-2:2007 CISPR 11:2009+A1:2010.
Complaints and requests should be addressed to:
Little Doctor Europe Sp. z o.o.
57G Zawila Street, 30-390, Krakow, Poland
Service phone: +48 12 2684748, 2684749
Produced by Nihon Seimitsu Sokki Co., Ltd.
Address: 2508-13 Nakago Shibukawa Gunma 377-0293 Japan
Exporter: Little Doctor International (S) Pte. Ltd.
Address of Exporter: 35 Selegie Road #09-02 Parkline Shopping Centre, Singapore
188307
10

Advertisement

Table of Contents
loading

Table of Contents