Mounting - Siemens PPU 26x.3 series Manual

Name Function
H501 BUS_SYNC
H502 BUS_FAULT
H505 Temperature alarm (red) Lit
7.3.1

Mounting

Installation
The module can be attached at a suitable position via the four mounting holes (e.g. behind the
machine control panel or in the control cabinet). The selection of the appropriate mounting
position depends on the interfaces used and the associated maximum cable lengths. Four
standard torx-slotted screws T20/M4 are used to attach the module.
MCP Interface PN dimension drawing
Figure 7-12
PPU and components
Manual, 10/2015, 6FC5397-2DP40-5BA3
Status Meaning
Not lit No PROFINET communication.
Lit PROFINET is synchronized (STOP state).
Flashes (0.5 PROFINET is synchronized (RUN state).
Hz)
Lit PROFINET group fault.
At least one temperature limit is being exceeded.
Dimensions
Connectable components
7.3 MCP Interface PN
127