Connectable components
7.2 MCP 310 USB
7.2.2
Mounting
Installation and mounting
The recommended machine control panel mounting is shown in the following diagram:
The machine control panel is mounted from the front in a rectangular cut-out and attached
using tension jacks (0.5 Nm tightening torque). The tension jacks are included in the scope of
delivery. Tension jacks are also available as a spare part, see Section Spare parts and
accessories (Page 122).
Figure 7-7
114
Mounting panel cutout
PPU and components
Manual, 10/2015, 6FC5397-2DP40-5BA3