idp SOLID Series User Manual page 56

RF(PC/SC) : Contactless Smartcard Encoding
In SOLID-310 printer, a contactless smartcard encoder can be installed and SOLID-310
printer has the internal and external contactless smartcard encoder. RF(PC/SC) is to read
and write the contactless smartcard. Using internal encoder, the printer brings a card into
the printer from input hopper and encodes a smartcard. Using external encoder, after
putting a card on the top cover, you can encode because the antenna installed under the
top cover is used. Therefore, "Batch" is applied only to the internal contactless smartcard
encoding.
"Contact" is to contact with the contactless smartcard electrically and initialize.
"Reset" is to finish the function electrically. After "Contact", you can run "Read", "Write" and
"Clear".
"Get UID" is for getting Chip Serial Number(CSN)
"Read" and "Write" are to read and write the defined data (Name, Address and Phone).
These could not be applied to all cards.
"Clear" is to clear the displayed data (ATR, Name, Address and Phone).
In case the data is read and written using APDU, Read/Write can be done by APDU
commands.
"Load APDU" is to read the stored APDU commands.
"Save APDU" is to save the displayed APDU commands.
"Clear APDU" is to clear the APDU section.
"Send APDU" is to run the APDU commands.
Batch process repeats the following steps sequentially, Card "IN"  Move "RF"  RF
"Connect"  Get UID RF "Discontact"  Card "OUT"
56