idp SOLID Series User Manual page 52

(2) Select printer and control
When you execute CardPrinterTest, it will search connected printers by USB and Network
automatically and SOLID-310 printer connected to USB has higher priority. Other printers could be
selected by pull-down menu. You can test all function with connected printer.
. Control is consisted by SBS(Step by Step), Move, Rotate, Etc. section and you can control
printer by each step.

SBS
SBS is to operate SOLID-310 printer in SBS(Step-By-Step) mode which you can control
the printer using commands. In SBS mode, after printing data transmission, printing a card
will be run only by clicking "DoPrint". It is the main difference between NORMAL mode and
SBS mode. When you click "Start", SOLID-310 is operated in SBS mode, and existing
spooled data will be eliminated. To exit SBS mode, click "Stop".

Card
Card is to bring a card into printer and eject a card. "In" is to move a card from input
hopper to printer and "Out" is to move a card from printer to output hopper. In case the
flipper is installed, "Back" ejects a card to the back side.

Move
Move is to move a card to specific position in the inside of printer. "Print" is to move a card
to the printing position, and "Mag." is to the magnetic encoding position, and "IC" is to the
contact smartcard encoding position, and "RF" is to the contactless smartcard encoding
position. "To Rotator" is to move a card from printer to flipper and "From Rotator" is to
move a card from flipper to printer. "from In" is to move a card from the card in sensor to
where you define position, and "from Out" is to move a card from the card out sensor to
where you define position.

Rotate
Rotator is to flip over a card in the printer installed flipper. "Auto" is to move a card from
printer to flipper and flip over a card and move a card to the printing position automatically.
"Batch" is to repeat "Auto" as many times as the number of set. "To Bottom" is to turn to
the backside of card and "To Top" is to turn to the front side of card.

Etc
"Cleaning Roller" is to clean the roller by cleaning card automatically. "Use Log" is to
display log in message space.
(3) Print
52