idp SOLID Series User Manual page 37

③ Click "Card Printer" tab.(If laminator or flipper is installed, you can setup laminator or
flipper setting value by "Laminator" tab or "Flipper" tab..
④ To show firmware version, serial number of printer and serial number, resister & type of
print head.
⑤ To show print area. It shows
⑥ To set print area. Please set it properly to print on an entire card because SOLID-310
is a direct thermal card printer. When you click "⑦ Print", a card is printed as like "④
example". Please set values properly that all circles of each corner are printed and
blank spaces are 0.4mm ~ 0.5mm in the top and the bottom of a card. Please set
values by following order.
X Start Position: Please set right and left properly by adjusting X position.
Y Start Position: Please set the start position of printed example image and blank
space in the top is 0.4mm ~ 0.5mm.
Y End Position: Please set the end position of printed example image and blank
space in the bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger value for
"Y scale" than default.
Y Scale: Please set to show circles in the bottom.
To set density. SOLID-310 enables to set different density for each color, resin black
and overlay. So, please set each density for high quality. Please optimize the quality
by adjusting each value. To optimize, you repeatedly adjust the density and print a
Calibration card and check the print state until you get the optimum.
If your printer is SOLID-310 R model, please do not install ribbon. You can set
density with Rewritable cards. Please adjust total density only.
Total Density: To set all of the density (Color, Black and Overlay) at one time.
If your printer is SOLID-310 R model, when the density is too strong, you will
have darker background color. (Background color may vary depending on card
type.) When density is proper, texts and images are printed clearly and there is
no background color. When density is too low, texts and images are printed dull.
for user convenience.
exaggeratingly
37