idp SOLID Series User Manual page 53

Print can be done through the CSD file which is designed by Smart Design program. Following the
steps in this section.
1. Click "..." button and select the CSD file.
2. Click "Open" button to prepare CSD file to print.
Click "Print" Button to move print data to spool. In the NORMAL mode, Click "Print" button
3.
to print a card, but in the SBS mode, "Print" button to transmit a printing data from PC to
printer and wait for printing. Therefore, you must click "DoPrint" to print in SBS mode. This
function is for detail control of printer.
4. Click "Close" button to close CSD file.
(4) Batch
Batch is to repeat encoding/decoding test continuously. In the Repeat, you input the number of
repeat and click "Batch Start", then the test is run as many times as the number of set. When you
check "Include Card In/Out", each time the printer bring a card from input hopper and perform an
encoding test and eject the card. But if not, encoding test will be done only by one card. At that time,
if there is no card in the printer, the printer bring a card into the printer from input hopper and repeat
the encoding test on the card, and if there is a card in the printer, the encoding test is performed on
the card repeatedly. "Card Holding" is activated when "Include Card In/Out" is ticked. When "Card
Holding" is ticked and the repeat number is set, the printer repeats the encoding test as many times
as the number of set in the "Card Holding" without ejection. When it is completed, the printer ejects
the card and brings a new card into the printer and starts testing.
In the Setting, "Retry" is to retry the encoding test when the error occurred. "Prompt on Error" is
to display Pop up Message when the error occurred. If not, Error number will be counted without
message. The number of error is displayed at Error section.
(5) Encoding
Magnetic: Magnet Stripe Encoding
"Read" is to read and display the data from magnetic stripe card. It is composed of "Do
Read" and "Read All Buffer" and runs "Do Read" and "Read All Buffer" sequentially.
"Do Read" is to read the data from magnetic stripe card and store the data in the buffer.
"Read All Buffer" is to transmit the date stored in the buffer to PC. If the track number is
ticked, the data of the ticked track is only transmitted to PC.
53