Table of Contents
Advertisement
(See Entry of New Calibration
Code - Page 9).
3 When the instrument passes all
internal functional checks on
start up, the screen displays the
current batch code and prompts
the user to insert a sensor.
If start up fails, an error message
is displayed.
Performing a Test (Analysis Mode)
1 Slide the front catch to the right,
and open the instrument case
fully.
2 Remove the sample container.
Rinse and then fill to the stepped
line with the water sample.
3 Replace the filled sample container
in the instrument.
4 Tear open the foil along the
pre-cut marks, in the manner
shown. Holding the sensor
through the foil pack, expose
the connecting tracks.
6
Advertisement
Table of Contents
