Table of Contents
Advertisement
Error Messages
The ChloroSense features an error detection system to
guide the user. After correcting each error, press
reset the instrument. Always use a fresh portion of sample
if a sensor has been immersed in the water sample :-
Error
1 Remove sensor, dry the contacts
(see overleaf).
2 Remove calibration chip.
Press
key and use Palintest check
standards (CS 180).
Remove and discard the sensor. Dry
the contacts (see overleaf).
Press
key and start again with
fresh sample and sensor.
Remove the sensor.
Press
key and start again with
fresh sample and sensor.
Remove the sensor.
Press
key and start again with
fresh sample and sensor.
Action
key to
10
Advertisement
Table of Contents
