Attaching The Front Brackets To The Rack - IBM Storage Networking SAN128B-6 Installation, Service And User Manual

Figure 16. Attaching the front brackets
1. The SAN128B-6 device
2. Front brackets, right and left
3. Screws, 8-32 x 5/16-in., flathead Phillips

Attaching the front brackets to the rack

About this task
Complete the following steps to install the device in the rack.
Procedure
1. Position the device in the rack, as shown in (Figure 17 on page 30), providing temporary support
under the device until the rack kit is fully secured to the rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and
two retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and
two retainer nuts. Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
29
Mounting the switch