Backing Up The Configuration; Powering Down The Device - IBM Storage Networking SAN128B-6 Installation, Service And User Manual

4 4 460400
5 5 460500
6 6 460600
7 7 460700
8 8 460800
9 9 460900
10 10 460a00
11 11 460b00
12 12 460c00
13 13 460d00
14 14 460e00
15 15 460f00
16 16 461000
17 17 461100
18 18 461200
19 19 461300
20 20 461400
21 21 461500
22 22 461600
23 23 461700
<Output truncated>

Backing up the configuration

About this task
It is recommended that you back up the configuration on a regular basis to ensure that a complete
configuration is available for downloading to a replacement switch.
Procedure
1. Log in to the device as the admin user.
2. Back up the device configuration to an FTP server by entering the configUpload command and
following the prompts.
sb_70:admin> configupload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 192.168.0.100
User Name [user]: anonymous
Path/Filename [<home dir>/config.txt]: /dumps/supportsave/pz/switch85/G20-1.txt
Section (all|chassis|switch [all]): all
configUpload complete: All selected config parameters are uploaded
This command uploads the device configuration to the server, making it available for downloading to
a replacement device if necessary.
Note: If Virtual Fabrics (VF) is enabled, you must enter configUpload for each VF separately.

Powering down the device

About this task
Complete the following steps to power down the device.
Procedure
1. Shut down the Fabric OS software using the sysShutdown command.
2. Identify the power-on switches in the nonport-side of the device.
3. Power off both power supplies by setting each power switch to the "O" position.
4. Unplug the power cables from the power source before servicing the device or FRUs.
id N32 Online
id N32 Online
id N32 Online
id N32 Online
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
-- N32 No_Module
FC F-Port 10:00:8c:7c:ff:5c:c5:01
FC F-Port 10:00:8c:7c:ff:58:4c:00
FC F-Port 10:00:8c:7c:ff:5c:c9:01
FC F-Port 10:00:8c:7c:ff:5c:bd:00
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
FC
Initial Setup and Verification
43