Attaching The Brackets For 4002-Y2B And; 4002-Y4B; Attaching The Brackets For 4002-Y2A, Y4A, Y2C, And Y4C - IBM 4002-Y2A Installation And User Manual

v Temperature: Since the temperature within a rack assembly may be higher than
v Mechanical loading: Do not place any equipment on top of a rack-mounted unit.
v Circuit overloading: Be sure that the supply circuit to the rack assembly is not
v Grounding: Rack-mounted equipment should be properly grounded. Particular
Use the following steps to mount devices in rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two
2. Attach the mounting brackets to the sides of the device as illustrated in
Figure 19. Attaching the brackets for 4002-Y2B and 4002-Y4B
Figure 20. Attaching the brackets for 4002-Y2A, Y4A, Y2C, and Y4C
18
Ethernet y-series Installation and User Guide: Installation and User Guide
the ambient room temperature, check that the rack-environment temperature is
within the specified operating temperature range. (Refer to "Displaying the
temperature" on page 43.)
overloaded.
attention should be given to supply connections other than direct connections to
the mains.
L-shaped mounting brackets and mounting screws.
Figure 19 and Figure 20.
Note: 4002-Y2A, Y4A, Y2C, and Y4C device brackets are mounted using three
screws, as shown in Figure 20.