Administrator Settings-Emc Resilience Mode - Cisco TelePresence EX60 User Manual

69 Managing the Settings
Administrator Settings—EMC Resilience Mode
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
To enter the Administrator Settings, you
must tap Administrator, located below
Restart, as outlined. This will take you to the
Administrator Settings right away.
Note that access to these settings may have
been password protected by your Video
Support Team.
About EMC Resilience
If the Touch controller is used in
environments with considerable
amounts of electromagnetic noise
present, you may experience an
appearance of false signals—as
if someone tapped the Touch
controller when obviously nobody
did so.
To cope with this you may set the
EMC Resilience Mode to On. You
must then press and hold for a
little while, rather than just tap, in
order to make the system aware of
your tapping. This will prevent the
appearance of spurious signals.
Caution! There is no Cancel
function letting you exit the menu
undoing any changes you have
made. Take care!
D15016.07 User Guide Cisco TelePresence
EX60, EX90
Produced: October 2013 for TC6.3
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.