Administrator Settings-Web Snapshots - Cisco TelePresence EX60 User Manual

70 Managing the Settings
Administrator Settings—Web Snapshots
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
To enter the Administrator Settings, you
must tap Administrator, located below
Restart, as outlined. This will take you to the
Administrator Settings right away.
Note that access to these settings may have
been password protected by your Video
Support Team.
About snapshots
You may gain access to your video
system through its web interface, see
the Administration Guide for more.
From the web interface you may gen-
erate snapshots of the video stream
from your system. You may also
generate snapshots from the outgoing
video of the far end system.
However, you cannot take snapshots
unless you have set the Allow Web
Snapshots to ON, as shown here.
Snapshots cannot be taken if the call is
encrypted. Encryption will disable the
snapshot feature at both ends, regard-
less of the local settings of the Allow
Web Snapshots parameter.
The web snapshot feature applies to
Point-to-Point as well as MultiSite calls
(but to unencrypted calls only).
In this context a MultiWay call should
be regarded as a variant of Point-
to-Point call as it is the MCU who is
controlling the call and your system is
connected to the MCU as in a Point-
to-Point call.
Caution! There is no Cancel function
letting you exit the menu undoing any
changes you have made. Take care!
D15016.07 User Guide Cisco TelePresence
EX60, EX90
Produced: October 2013 for TC6.3
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.