Administrator Settings-Call Details - Cisco TelePresence EX60 User Manual

63 Managing the Settings
Administrator Settings—Call Details
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
To enter the Administrator Settings, you
must tap Administrator, located below
Restart, as outlined. This will take you to the
Administrator Settings right away.
Note that access to these settings may have
been password protected by your Video
Support Team.
About Call Details
If you enable Auto Answer the
system will respond by itself to
incoming calls after a delay specified
by you. Note that an activated auto
answer may not provide you with
the privacy desired. In the example
shown here Auto Answer is set to
Off.
On certain occasions you may have
to change the bandwidth (and
hence the quality) of the call. Some
configurations may have different
incoming and outgoing bandwidths
(typically ADSL connections), and
you may specify the default call rate
to ensure a stable video quality.
The default protocol may also be
specified. In the example shown, the
protocol has been set to SIP.
Caution! There is no Cancel
function letting you exit the menu
undoing any changes you have
made. Take care!
D15016.07 User Guide Cisco TelePresence
EX60, EX90
Produced: October 2013 for TC6.3
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.