Administrator Settings-Emc Resilience Mode - Cisco TelePresence EX90 User Manual

Cisco TelePresence System EX90
Administrator Settings—EMC Resilience Mode
If the Touch controller is used in environments with
considerable amounts of electromagnetic noise
present, you may experience an appearance of false
signals—as if someone tapped the Touch controller
when nobody obviously did so.
To cope with this you may set the EMC Resilience
Mode to On. You must then press and hold for a little
while, rather than just tap, in order to make the system
aware of your tapping. This will avoid the appearance
of false signals.
As long as the system is used in environments without
consideable amounts of electromagnetic noise, the
setting should be set to Off (as shown).
User guide EX90, TC4.2, July 2011.
D14724.06
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
All manuals and user guides at all-guides.com
41
User guide
www.cisco.com