Connecting The Ex90 - Cisco TelePresence EX60 User Manual

6 Getting up and going

Connecting the EX90

Remove cover to get access to
the connector sockets.
The cover is vented in the
lower left corner (external
view) due to the rear mounted
loudspeaker.
When mounting the cover back
on, make sure the vents are
where the speaker is
(as shown).
   
 Connect your PC here if you need to share a single LAN connection with the EX90.

Connect your EX90 to the LAN.
 USB socket (for future use).
 Connect the touch screen controller.
 HDMI In (inner socket) and HDMI
 Connect PC video (for use as your PC screen)

Connect PC audio

Connect power here.
* HDMI out is used when connecting an extra monitor (typically for presentations).
Sockets
Cover vents
Pull out
Connect headphones
and external
microphone here.
   
Out* (outer socket).
A resolution of 1920 × 1200 is recommended. However, other
resolutions may also be used as shown below.
Digital input via DVI Analog input via DVI
1920 × 1200 (recommended) 1
920 × 1200 (recommended)
1920 × 1080
1776 × 1000 (not full screen)
1680 × 1050
1680 × 1050
1600 × 1200 (not full screen)
1600 × 1200 (not full screen)
1440 × 900
1440 × 900
1400 × 1050 (not full screen)
1280 × 1024 (not full screen)
1280 × 1024 (not full screen)
1280 × 960 (not full screen)
1280 × 800
1280 × 768 (not full screen)
1280 × 720 (not full screen)
1152 × 648 (not full screen)
1024 × 768 (not full screen)
1024 × 768 (not full screen)
960 × 600 (not full screen)
800 × 600 (not full screen)
800 × 600 (not full screen)
•
You may connect an external monitor to your EX90 to have
it work with two monitors at the same time. The second
monitor can be configured to show presentations instead
of having everything on a single screen.
•
To enable the use of a second monitor the system must
be configured for it. This is done via the web interface
using the Video DefaultPresentationSource setting. Doing
so is described in the EX90 Administrator Guide which is
available separately for download .
Using EX90 as PC screen
If you choose to use your EX90 as
your PC screen, connect your PC
to the sockets on the rear panel
as shown below left. A resolution
of 1920 × 1200 is recommended.
However, other resolutions may also
be used as shown in the left table.
Your EX90 will then serve as your
PC screen outside calls. In a call tap
View desktop to see the desktop.
Your desktop is not exposed to the
other side.
In a call you may view your PC
screen without sharing it with the
remote site(s). If the thumbnail
image showing the other participants
obstructs important parts of your
PC-screen you may move it in the
same way as you may with a PiP
(see "Moving the self-view PiP" on
page 27).
Screen resolution must be set
via the web interface, using the
Video Output HDMI [1] Resolution
setting. For details on this, see the
EX90 Administrator Guide, which is
available separately for download.
D15016.07 User Guide Cisco TelePresence
EX60, EX90
Produced: October 2013 for TC6.3
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.