3.10 - SYSTEM DISARMING WITHOUT ALARM MEMORY
If the TAG is detected
when ignition is switched ON, t
disarms
otherwise press remote control button "1".
Disarming will be confirmed by 3 Beeps, 3 flashes of the turn indicators and
the powering OFF of the
status LED.
3.11 - SYSTEM DISARMING WITH ALARM MEMORY
If an alarm event occurs while the system is armed, it will be signaled on
disarming (ignition key ON) by 2 flashes of the turn indicators and 2 Bops.
The last cause of alarm can be identified by observing the status LED and
counting the flashes.
Ignition attempt:
Seat/Topcase
tampering:
Cable tampering:
Tilt/Shock
detection:
PAGE 7
he system automatically
The alarm system is factory preset with some of the features disabled as
Self-rearming (anti-distraction)
The alarm system confirms the execution of an operation through
acoustic and optical (LED and turn indicators) signals.
excluded.
For use in emergency situations. Panic alarms can be triggered as many times
as necessary but at least 5 sec. must elapse between 2 consecutive alarms.
Pressing remote control button "2" will immediately activate the siren and the
turn indicators for approx. 30 sec. To turn off the panic alarm simply press
button "2" again.
The panic alarm can be triggered with either an armed or disarmed system.
When the system is armed, the sensor will trigger an alarm whenever motion is
detected. The tilt sensor can be excluded.
4.0 - PROGRAMMABLE FEATURES
detailed below.
Factory settings
Feature
Acoustic signals
Panic a
larm
Tilt sensor
Enabled (do not modify)
Passive arming
Anti-hijack
Pre-alarm
4.1 - OPTICAL/ACOUSTIC SIGNALS
4.2 - PANIC ALARM VIA REMOTE CONTROL
4.3 - TILT SENSOR
Status
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
both
Acoustic signals can be
PAGE 8