Table of Contents
Advertisement
10.0 - PROGRAMMABLE FEATURES
To either enable or disable one of the programmable features proceed as
indicated hereafter.
NB: Remember to ALWAYS arm and disarm the alarm before programming.
1
With the alarm disarmed, lift the seat or
2
3
The LED will light up for approx. 1 sec.
4
While the LED is ON simultaneously
press the 2 buttons on the remote control.
A Beep and a Bop will confirm the system
is in programming mode.The LED will light
PAGE14
topcase.
Turn ignition key to ON .
up steady.
After pressing both buttons simultaneously (step 4), program the features
according to your needs.
TO ENABLE
Press button 1
Button 1: TO ENABLE
Acoustic signals
Button 2: TO DISABLE
Button 1: TO ENABLE
Panic siren
Button 2: TO DISABLE
11.0 - PROGRAMMING EXAMPLE
To help you understand the programming procedure, here below is an
example showing how to enable both features.
Keep in mind that, at every button press, the system automatically scrolls to the
next feature.
!
With the alarm disarmed, l
ift the seat or open the t
!
Turn ignition key to ON; the LED will light up for 1 sec
!
While the LED is ON, simultaneously press the 2 buttons on the remote
control. wo Beeps
T
will confirm that the
The LED will turn ON steady
.
!
Press remote control button 1 a Beep
,
have
been enabled
.
!
Press button 1 again, a Beep will confirm that the panic siren has been
enabled.
!
When the last feature is programmed, the system automatically exits the
programming mode. Three
Bops
followed by
the procedure. T
he
status LED will also
!
Turn ignition key OFF and close the topcase/seat.
NB:
You can
exit
programming mode at any time by turning
P
rogrammed eatures will automatically be saved while the others will remain
f
unvaried.
TO DISABLE
Press button 2
EXIT PROGRAMMING
opcase.
.
system is in
programming
mode.
will confirm that
acoustic signal
s
a Beep
will confirm the end of
turn
OFF
.
ignition
key OFF.
PAGE15
Advertisement
Table of Contents
