Table of Contents
Advertisement
REPLACEMENT OF THE INJECTORS
Select the injectors to be replaced according
to the "TABLE FOR THE CHOICE OF THE
INJECTORS".
The
nozzle
diameters,
hundredths of a millimetre, are marked on
the body of each injector.
If the injectors are not supplied they can
be obtained from the "Service Centre".
REPLACEMENT
INJECTORS OF THE COOKTOP
BURNERS
To replace the injectors proceed as follows:
•
Remove pan supports and burners
from the cooktop.
•
Using
a
wrench,
injectors "J" (figs. 5.3, 5.4) with those
most suitable for the kind of gas for
which it is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
SETTING THE MINIMUM OF THE
COOKTOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The flame adjustment is done in the
following way:
•
Turn on the burner.
•
Turn the tap to the 'MINIMUM' position.
•
Take off the knob.
•
With a small flat screwdriver turn the
screw "A" to the correct regulation (fig.
5.5).
Normally for LPG tighten up the
regulation screw.
26
expressed
in
OF
THE
substitute
the
Semirapid burner
Triple-ring
burner
J
Fig. 5.3
J
Fig. 5.4
A
Fig. 5.5
Advertisement
Table of Contents
