Tools Needed - GE GDF510PxJ Series Technical Service Manual

AC Voltage
• Circulation Pump: 120 VAC, .8 amp – 3.8 LRA, 8GPM @ 5PSI
• Drain Pump: 120 VAC, 27 ohms, .65 amp, ~70 second cycle
Heater 120 VAC
•
Wet
Watts 793
Ohms 16.4
Amps 6.6
• Tub TCO: 120 VAC, 210°F +/- 10°F Manual Reset
• Main Control: Input 120 VAC, Output 120 VAC, and Output 5 & 13.5 VDC
DC Voltage
• Door Switch: 13.5 VDC
• Water Valve: 13.5 VDC, 32 ohms, .83 GPM, ~1 minute cycle time
• UI Control: 13.5 VDC (some models have 13.5 VDC output to detergent module)
• Detergent Cup: 13.5 VDC, 25 ohms, .5 second to release detergent cup, 15 seconds to release rinse aid
• Turbidity Sensor: 5 VDC to LED, 10K ohms
• Flood Switch: 13.5 VDC, .42 amp
•
Resistance Temperature
20k
11k
5.8k
3.4k
2.1k
1.3k
1/4" & 5/16" nut driver
R2 Quadrex bit
#15 and #20 Torx bits
#2 Phillips head screw driver
Two 5/32" Allen wrench's (or similar size tool, see the
Door Removal section in this guide)
Dry
625 +/- 5%
23.2 +/- 5%
5.2 +/- 5%
50°F
75°F
100°F
125°F
150°F
175°F

Tools Needed

Adjustable wrench
Two pocket type screwdrivers
Pliers and needle nose pliers
Volt / Ohm meter (AC, DC, and ohms) with "Needle"
Type Probes
Optional: Clear door (Part #: WX05X20002)
– 9 –