GE WD35X10394 Installation Instructions

GE Appliances
Installation Instructions
Dry Enhancement Kit
WD35X10394
February 2013
Dishwasher Dry Performance
Verify proper heater operation, check for error
codes in diagnostic error mode, including
thermistor and/or wash temperature error codes.
Enter service mode to test heater operation. Full
directions to enter diagnostic and service mode
can be found in service guide 31-9226 or the
dishwasher's mini-manual.
If none of the above issues apply, follow all steps
in these instructions.
Step I - Remove Power from the
Dishwasher
Step 2 - Remove Inner Door Vent
Cover
To remove inner door vent cover, use 2 pocket
screw drivers, turn counter clockwise (Consult
Service Guide 31-9226 or Mini-manual). Old
vent cover should be discarded.
Models:
GDF510P DO
Parts Included:
This kit includes all parts needed for the above
model.
° Main control board WD21X10530
° Vent cover
° Foam strip (black in color)
° Door harness wire tie (may not be needed)
° Installation instructionsWD00X1019
Tools You Will Need:
• 1/4" Nutdriver
• T15Torx screwdriver
• Hinge locking tool (see service guide 31-9226)
Step 3 - Remove complete Door
assembly
° Consult Service Guide 31-9226 or Mini-manual
for door removal process.
° A new wire tie for the door wire harness is
included in the kit. Should the original tie
become damaged, it must be replaced.
Step 4 - Separate the Door
° Consult Service Guide 31-9226 or Mini-manual
for door separation process.
GE Appliances
General Electric Company
Louisville, KY 40225
WD00X1019