GE GDF510PxJ Series Technical Service Manual page 27

5. Remove two 1/4 in. hex head screws at the
bottom of the door.
Remove two 1/4 in. hex head screws
6. Locate the hinge pin locking point hole in tabs
shown below).
Tab
Left side
hinge arm
7. Insert a 5/32 Allen wrench (or similar size tool)
through this hole, gradually open door to 30°F
and continue to insert the Allen wrench through
of the hinge has completed.
TIP
best results and easier door installation.
8. Repeat the last step on the opposite side.
9. Lift the door up approximately 3 Inches.
10. Tilt the door in (vertical).
– 27 –
(Continued next page)