Main Conduit
The Main Conduit supplies water to the mid spray
arm, bottle wash (on some models) and the upper
spray system (on some models).
Main Conduit Removal
1. Remove both lower and upper racks.
2. Remove the lower spray arm.
3. Remove the two 1/4 in. hex head screws
securing the mid spray arm docking port. The
docking port will stay attached to the main
conduit.
Remove two 1/4 in.
hex head screws
4. Push on the tab and pull up on the conduit to
release from the diverter.
5.
conduit to complete the removal.
Heater Clip
NOTE: Using rinse aid or water on the main conduit
seal in the diverter will aid main conduit installation.
Spray Arms
Lower and Mid Spray Arms are twist lock design and
are the similar size and shape. The lower spray arm
has heat shields on the bottom and is attached to
the diverter. It is possible to reverse the spray arms,
which will result in poor washability complaints.
Care must be taken to reassemble in proper position.
Some models have an upper spray system which is
also twist lock.
– 59 –