Menu System - Nibe VVM 310 EMK Installer Manual

Menu system

When the door to the indoor module is opened, the
menu system's four main menus are shown in the dis-
play as well as certain basic information.
Outdoor
temperature Indoor temperature - (if room sensors are installed)
INDOOR CLIMATE HOT WATER
SERVICE
MY SYSTEM
Temporary lux (if Estimated amount of
activated) hot water
MENU 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See informa-
tion in the help menu or user manual.
MENU 2 - HOT WATER
Setting and scheduling hot water production. See inform-
ation in the help menu or user manual.
MENU 3 - INFO
Display of temperature and other operating information
and access to the alarm log. See information in the help
menu or user manual.
MENU 4 - MY SYSTEM
Setting time, date, language, display, operating mode
etc. See information in the help menu or user manual.
MENU 5 - SERVICE
Advanced settings. These settings are not available to
the end user. The menu is visible when the Back button
is pressed for 7 seconds, when you are in the start
menu. See page 54.
48 Chapter 7 | Control - Introduction
Hot water temp.
Information about
operation
INFO
SYMBOLS IN THE DISPLAY
The following symbols can appear in the display during
operation.
Symbol Description
This symbol appears by the information sign
if there is information in menu 3.1 that you
should note.
These two symbols indicate whether the
compressor in the outdoor module or addition-
al heat is blocked in VVM 310.
These can, for example, be blocked depend-
ing on which operating mode is selected in
menu 4.2, if blocking is scheduled in menu
4.9.5 or if an alarm has occurred that blocks
one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase or
lux mode for the hot water is activated.
This symbol indicates whether "holiday set-
ting" is active in 4.7.
This symbol indicates whether VVM 310 has
contact with NIBE Uplink.
This symbol indicates the actual speed of the
fan if the speed has changed from the normal
setting.
Accessory NIBE F135 needed.
This symbol is visible in installations with
active solar accessories.
This symbol indicates whether pool heating
is active.
Accessory needed.
This symbol indicates whether cooling is act-
ive.
Heat pump with cooling function required.
OPERATION
To move the cursor, turn the control knob to
the left or the right. The marked position is
white and/or has a turned up tab.
SELECTING MENU
To advance in the menu system select a main menu by
marking it and then pressing the OK button. A new
window then opens with sub menus.
NIBE VVM 310