Menu System - Nibe VVM 320 Installer Manual

Menu system

When the door to the indoor module is opened, the
menu system's four main menus are shown in the dis-
play as well as certain basic information.
Outdoor
temperature Indoor temperature - (if room sensors are installed)
INDOOR CLIMATE
SERVICE
MY SYSTEM
Temporary lux (if Estimated amount of
activated) hot water
Menu 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See inform-
ation in the help menu or user manual.
Menu 2 - HOT WATER
Setting and scheduling hot water production. See in-
formation in the help menu or user manual.
Menu 3 - INFO
Display of temperature and other operating informa-
tion and access to the alarm log. See information in
the help menu or user manual.
Menu 4 - MY SYSTEM
Setting time, date, language, display, operating mode
etc. See information in the help menu or user manual.
Menu 5 - SERVICE
Advanced settings. These settings are not available to
the end user. The menu is visible when the Back button
is pressed for 7 seconds, when you are in the start
menu. See page 47.
NIBE™ VVM 320
HOT WATER Hot water temp.
Information about
operation
INFO
Symbols in the display
The following symbols can appear in the display during
operation.
Symbol Description
This symbol appears by the information
sign if there is information in menu 3.1
that you should note.
These two symbols indicate whether the
compressor in the outdoor unit or addi-
tional heat is blocked in VVM 320.
These can, for example, be blocked de-
pending on which operating mode is se-
lected in menu 4.2, if blocking is sched-
uled in menu 4.9.5 or if an alarm has oc-
curred that blocks one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase
or lux mode for the hot water is activated.
This symbol indicates whether "holiday
setting" is active in 4.7.
This symbol indicates whether VVM 320
has contact with NIBE NIBE Uplink.
This symbol indicates the actual speed of
the fan if the speed has changed from
the normal setting.
Accessory NIBE F135 required.
This symbol indicates whether pool
heating is active.
Accessory needed.
This symbol indicates whether cooling is
active.
Accessory needed.
Operation
To move the cursor, turn the control knob
to the left or the right. The marked position
is white and/or has a turned up tab.
Selecting menu
To advance in the menu system select a main menu by
marking it and then pressing the OK button. A new
window then opens with sub menus.
Chapter 7 | Control - Introduction 41