Nibe VVM 310 EMK Installer Manual page 20

CONNECTING TO HEAT PUMP
You can find a list of compatible air/water heat pumps
on page 18.
VVM 310 is not equipped with shut off valves; these
must be installed outside the indoor module to facilitate
any future servicing.
-EB15
-QM40
-EB101
-XL1
-QZ2
-FL10
-XL2
-QM1
CONNECTION DURING USE WITHOUT HEAT
PUMP
Connect the pipe for docking in from the heat pump
(XL8) with the pipe out to the heat pump XL9.
-EB15-FL2
-EB15
-CM1
-XL8 -XL9
-EB15
20 Chapter 4 | Pipe connections
-EB15-FL2
-EB15
-CM1
-XL8
-XL9
CONNECTING COLD AND HOT WATER
The mixer valve must be installed if the factory setting
is changed to ensure that the temperature can exceed
60 °C. National regulations must be observed. The set-
ting is made in menu 5.1.1
-XL4
-XL3
-EB15-FL2
-EB15
-CM1
-EB15
CONNECTING THE CLIMATE SYSTEM
When connecting to a system with thermostats on all
radiators/underfloor heating coils, a relief valve must be
fitted, or a thermostat must be removed to ensure suf-
ficient flow.
-EB15-FL2
-EB15
-CM1
-EB15
(See page 55).
-FL1
-RM1 -QM40
-XL1
-XL2
NIBE VVM 310