Program Settings; Menu System - Nibe PCS 44 Installer Manual

Passive cooling for nibe f1145, f1245

Hide thumbs Also See for PCS 44:

Table of Contents

Available languages

relay (max 2 A) on the input circuit board (AA3), terminal

block X7.

If cooling mode indication is connected to terminal block

X7 it must be selected in menu 5.4, see

Program settings

Program setting of PCS 44 can be performed via the start

guide or directly in the menu system.

Start guide

The start guide appears upon first start-up after heat

pump installation, but is also found in menu 5.7.

If you do not make all settings via the start guide or need

to change any of the settings, this can be done in the

menu system.

Menu 5.2 - system settings

Activating/deactivating of accessories.

Menu 1.9.5 - cooling settings

Setting the minimum flow temperature, time between

cooling and heating, mixing valve settings as well as se-

lection of which room sensor is to control cooling.

Caution

Also see the Installer manual for F1145/F1245.

Table of Contents