Safety And General Information; Follow Safety Instructions; Decal Descriptions; Danger: Moving Auger - Chore-Time ULTRAFLO Series Installation And Operators Instruction Manual

Cage feeding systems for brood grow & layer installations
Table of Contents

Advertisement

ULTRAFLO
Cage Feeding Systems for Brood Grow & Layer Installations
®

Safety and General Information

Caution, Warning and Danger Decals have been placed on the equipment to warn of potentially dangerous
situations. Care should be taken to keep this information intact and easy to read at all times. Replace missing or
damaged safety decals immediately.
Safety–Alert Symbol
This is a safety–alert symbol. When you see this symbol on your equipment, be alert to the potential
for personal injury. This equipment is designed to be installed and operated as safely as
possible...however, hazards do exist.
Understanding Signal Words
Signal words are used in conjunction with the safety–alert symbol to identify the severity of the warning.
DANGER indicates an imminently hazardous situation which, if not avoided, WILL result in death or
serious injury.
WARNING indicates a potentially hazardous situation which, if not avoided, COULD result in death or
serious injury.
CAUTION indicates a hazardous situation which, if not avoided, MAY result in minor or moderate
injury.

Follow Safety Instructions

Carefully read all safety messages in this manual and on your equipment safety signs. Follow recommended
precautions and safe operating practices.
Keep safety signs in good condition. Replace missing or damaged safety signs.

Decal Descriptions

DANGER: Moving Auger

This decal is placed on the End Cap Weldment and Clean-out
cover.
Severe personal injury will result, if the electrical power is
not disconnected, prior to servicing the equipment.

DANGER: Electrical Hazard

Disconnect electrical power before inspecting or servicing equipment unless
maintenance instructions specifically state otherwise.
Ground all electrical equipment for safety.
All electrical wiring must be done by a qualified electrician in accordance with
local and national electric codes.
Ground all non-current carrying metal parts to guard against electrical shock.
Electrical disconnects and over current protection are not supplied with the
equipment.
MC656P
Safety and General Information
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ULTRAFLO Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents