Introduction - GE DigitalFlow GS868 Programming Manual

Introduction

Displaying Data
This chapter explains how to display measurement data in various
formats. Each of the two display screen panes may be programmed
independently.
Note: The instructions in this chapter assume that the left display
pane is active. If the right display pane is active, simply
[F1]-[F4]
change all
The following submenus are included in the Display Menu:
•
BIG
- displays a single measurement in large size text
• DUAL
- permits the simultaneous display of two measurements, in
the same screen pane, in standard size text
• GRAPH
- displays a graph of either velocity or volumetric flow
versus time
•
LOG
- displays the data stored in a log file either graphically or
numerically
•
SIGNL
- graphically displays any one of five transducer signals
versus time
• BACKL
- sets the time that the LCD display backlight remains on
before it is automatically turned off.
• SLEEP
- blanks out the display screen until a key is pressed.
Refer to Figure A-5 on page A-5 of Appendix A, Menu Maps, and
proceed to the appropriate section to set up the Model GS868 display
screen(s), using one of the listed submenus.
[F5]-[F8]
designations to .
March 2008
2-1