Entering Setup Data - GE DigitalFlow GS868 Programming Manual

Entering Setup Data

Programming Site Data
The signal limits and response times for the Model GS868 are
SETUP
specified via the submenu. While following the programming
instructions, refer to the menu map in Figure A-2 on page A-2 in
Appendix A, Menu Maps. The following three submenus are included
in this section:
•
SIGNL
- set the parameters related to the transducer signal
• AVRG
- specify the response of the meter to step changes
•
INIT
- initialize all parameters to default values.
• ADVAN
- setting parameters for mass flow and multiple K-factors.
SETUP
Enter the submenu by pressing [→] and
PROGRAM
prompt and complete the following steps:
Chan 1 SETUP
Channel PROGRAM
SET UP
SET UP
last selection appears here
SIGNL AVRG INIT
Proceed to the appropriate section to program the option selection
made at the above prompt. Remember to record all programmed data
in Appendix B, Data Records.
[F1]
[F1]-[F3]
Press
SETUP
desired
ADVAN
March 2008
Channel
at the
to select the
option.
1-19