Troubleshooting; Pcmcia Option Is Not Recognized By The Recorder (Pcmcia Matrix Does Not Appear); Pcmcia Init Service Is Not Possible; Pcmcia Full" Message Is Displayed On The Recorder - Honeywell DPR180 Manual

6.1 PCMCIA option is not recognized by the recorder (PCMCIA matrix does
not appear)
CHECK
Check if the flat cable connection
between PCMCIA board and CPU
board is correct.

6.2 PCMCIA INIT service is not possible

CHECK
Is PCMCIA memory card really
plugged into the driver?
Is problem corrected ?

6.3 "PCMCIA FULL" message is displayed on the recorder

CHECK
What is the threshold value in READ-
WRITE\PCMCIA matrix?
Is problem corrected ?

6.4 "PCMCIA NOT INIT" message is displayed on the recorder

CHECK

6.5 "PCMCIA BAD" message is displayed on the recorder

CHECK
Is the card readable by an external
driver?

6. TROUBLESHOOTING

DIAGNOSTIC / ACTION
1. NO: Check for the proper connection.
DIAGNOSTIC / ACTION
1. NO: Insert the card into the board.
2. NO: Verify you only use ATA flash card devices (see
Section 5 - Kits list for certified cards).
DIAGNOSTIC / ACTION
1. Increase this value to disable "PCMCIA FULL" message
display.
2. NO: Initialize PCMCIA card again with INIT utility in
PCMCIA / SERVICE matrix and increase the number of
records for the files which are too small.
DIAGNOSTIC / ACTION
1. Initialize the card by using INIT menu in
PCMCIA / SERVICE matrix.
DIAGNOSTIC / ACTION
1. NO: Change the card.
2. YES: Run a TEST (PCMCIA / SERVICE).
- If the test is successful, then the card is OK.
- If the test stops before reaching 100 % of completion then
an area of the card is bad. The card has to be changed.
PCMCIA Option Manual
31