Honeywell DPR180 Manual page 13

B
26. Reinstall reinforcing bar (see ref. C, Figure 2-9)
27. Pass the PCMCIA flat cable through the opening at the rear of the printer chassis.
- Fix the PCMCIA flat cable on the rear metal sheet with the double-side adhesive tape.
(See ref. C, Figure 2-11). The adhesive tape is located on the flat cable.
- Ensure the printer carriage can move properly.
28. Replace the MMI flat cable plastic protection.
29. Connect the PCMCIA flat cable to the CPU board (see Figure 2-12). Ensure the connectors are
located correctly.
A
Figure 2-11
Figure 2-12
PCMCIA Option Manual
C
9