Overview; Warning - Honeywell DPR180 Manual

Before running your PCMCIA option, please read the following explanations on how to install it.

1.1 Warning

If you received your optional PCMCIA board as a spare part:
You are going to install your optional PCMCIA board.
To run properly, this application needs recorder firmware release 001AK or higher.
To determine the version of your recorder firmware, refer to your product manual (sub-section 3-2) or
read it on the recorder in SERVICE / MISCELLANEOUS, SOFTWARE.
If your recorder firmware release is lower than 001AK (or if you wish to upgrade it), follow the procedure
given in the PC Configurator Kit Notice (CK 214):
1. Install the PC configurator software (included in this kit) on your PC.
The minimum PC configuration required is a 486 with 4 Mb of RAM and 10 Mb free on your hard
disk.
The software is compatible with Windows 3.1, Windows 3.11 and Windows 95.
2. Install the new recorder firmware (included in this kit) on your PC.
3. Connect the PC - Recorder interface (Kit # 46190409-501 not included).
4. Upgrade the recorder firmware.
5. Install the optional PCMCIA board as described in this manual (refer to Section 2; sub-section
2.1)
6. Configure the PCMCIA option board as described in section 3 of the manual.
If you received your optional PCMCIA board with your recorder:
The PCMCIA board is already installed.
However, you have to configure the PCMCIA option as described in Section 3 of this manual.
Note that you can only upgrade the recorder firmware from the front panel of
the recorder (with a jack cable) using the PC Configurator Kit.

1. OVERVIEW

PCMCIA Option Manual
1