F1
3.1.3 Archives summary
Archived data on a PCMCIA memory card may be:
• charts i.e analog inputs, math results or communication data,
• analog alarms,
• digital events,
• recorder events: (no paper, end of paper, burnout ...)
3.1.4 Recorder firmware compatibility
The PCMCIA option is compatible with the 001AK recorder firmware or higher. Older firmware
revisions will not allow your recorder to recognize the PCMCIA option board, the recorder will need to be
updated (see the OVERVIEW section of this manual).
3.2 SETUP
3.2.1 PCMCIA communication interface configuration
The PCMCIA option board is detected at power up during the recorder's initialization time but, to be able
to use it, the INTERFACE parameter of the MISCELLANEOUS configuration matrix must be set to
PCMCIA.
The default configuration of this parameter is JACK, which allows to configure the recorder with the PC
Configurator software.
When the option board has been detected, the PCMCIA configuration matrices (READ-WRITE, PRINT
CONF and SERVICE) appear and this option becomes TRUE in recorder's hardware configuration (see
the CARD USED service in the MISCELLANEOUS matrix).
SUB-MATRIX
MISCEL
Definition:
How to modify it:
Possible choices:
Default value:
Note:
Note: The PCMCIA service functions are only available when the interface parameter is set to PCMCIA.
14
PCMCIA
HOLD
A
CTION
Figure 3-2: PCMCIA led in the 180mm or 250mm recorder
Determines which of the PCMCIA option board or the JACK board is
connected to the recorder.
Select a new value.
JACK
PCMCIA
JACK
This parameter cannot be modified by the PC Configurator software.
PCMCIA Option Manual
RESET
ACK
PARAMETER
INTERFACE
DISPLAY
F2
CLASSIFICATION
♦♦♣♣